So I just launched my new masternode.
I do a remote start, successful
run "dash-cli masternode list full | grep" lists it as enabled
perform ./dash-cli masternode status = error: {"code":-1,"message":"This is not a masternode\n"}
I perform a grep HotCold as well. I got my masternode to show up on the network then it dropped out. masternode is set to 1 in the dash.conf file. anything else that I am missing?
I do a remote start, successful
run "dash-cli masternode list full | grep" lists it as enabled
perform ./dash-cli masternode status = error: {"code":-1,"message":"This is not a masternode\n"}
I perform a grep HotCold as well. I got my masternode to show up on the network then it dropped out. masternode is set to 1 in the dash.conf file. anything else that I am missing?