Multiple addresses per wallet.

[DarkWater]

I know there are quite a few people who are running several addresses per wallet instance here, especially for masternodes. One of the issues I had ran into was I was not able to specify in the send feature where the funds were being drawn from. I would be pulling funds from one masternode to another and it took me looking in the blockchain explorer to figure out what was going on.

Would it be too cumbersome to be able to display per address registered in the wallet what the balance is? And also allow for addresses to be selected instead of just any available funds?

Just something I think could make the wallets that much better.

 

[thelonecrouton]

I know there are quite a few people who are running several addresses per wallet instance here, especially for masternodes. One of the issues I had ran into was I was not able to specify in the send feature where the funds were being drawn from. I would be pulling funds from one masternode to another and it took me looking in the blockchain explorer to figure out what was going on.

Would it be too cumbersome to be able to display per address registered in the wallet what the balance is? And also allow for addresses to be selected instead of just any available funds?

Just something I think could make the wallets that much better.

Settings > Options > Wallet tab > Enable coin control features

Check that, then under your Send page you'll have a new Inputs button, in there you can tick which inputs to use for a transaction, and from which addresses in the wallet.

 

[DarkWater]

That would be what I was looking for. Thanks for the info!