How-to debug Masternodes ?

Technologov

Technologov

Active member
Hello,

I have 2 different control wallets (Dash Core 12.1.4), and one of the wallets says my MN is 'ENABLED', while the other says 'NEW_START_REQUIRED' about the same MN (with same IP), when I look at 'all masternodes' tab in the GUI.

How to debug MN what's the true state ?

Thanks,
-Technologov
 
Are the wallets fully synced? On your MN try:
./dash-cli masternode status
or
./dash-cli mnsync status
 
Newar said:
Are the wallets fully synced? On your MN try:
./dash-cli masternode status
or
./dash-cli mnsync status
Click to expand...

'mnsync status' doesn't show the true picture. For example, if 'dashd' is running, but Sentinel is NOT, it will show that everything is great. Same for 'masternode status' command.

How to see if the network sees my Masternodes as ENABLED or NEW_START_REQUIRED ?
 
Yes.

UPDATE: hmm... looks like some GUI glitch in Dash Core.

Now the wallet that shown me 'NEW_START_REQUIRED' has auto-updated it's view and shows as 'ENABLED' ... I really don't understand it. The 'active' tab, that shows the Masternodes uptimes was also updated, and I see that my MNs were running ...

Even full PC reboot didn't help, but now it just auto-fixed by itself...
 
Last edited:
Any other commands, that can help me with debug ?

My nodes randomly get into any state... like into 'PRE_ENABLED' or 'WATCHDOG_EXPIRED' or 'NEW_START_REQUIRED'...
 
Do you have your sentinel updated as well?
 
You must log in or register to reply here.
Back
Top